ZRE-LAM A3 Fn335 Laminator Machine For Laminating Photo Cards Portable Thermal Lamination Film Paper Cutter For Personal Office School

We support wholesale and direct sales, you can contact us.
Collect stores and to be our follower, there will be more discounts!

A3 Fn335 Laminator Machine For Laminating Photo Cards Portable Thermal Lamination Paper Cutter laminating film For Personal Office

Attention: This product has been resold as a plastic machine and consumables used in the machine. Dear friend, please be sure to check the product you need when purchasing. If unsure, please contact customer service!（Support batch customization!）

Article No.: FN335
Support plastic seal size: A3 and downward compatible
Glue width: 330 mm
Size: 428x122x65mm
Glue thickness: 0.5 mm
Gluing speed: 355 mm/min
Maximum plastic packaging width: 330 mm
Heater temperature: 115 to 145 ° C
Voltage: 220 (US 110V)
Power: 300 W
Weight: 1.3 kg
Film stripping method: BS one-button film stripping
Noise: ≤ 55db (low noise)
Warm-up time: 1-2 minutes
Applicable scene: office and household
Overplastic film: (suitable for photos and documents)
Overplastic film thickness: 0.08 mm
A3 * 100pcs per package (307mm * 430mm)
A4 * 100pcs per package (220mm * 310mm)
A5 * 100pcs per package (160mm * 225mm)
A6 * 100pcs per package (110mm * 160mm)

Common problems and countermeasures of plastic packaging
1. Misty white spots appear.
① The temperature fails to reach the set point, and it needs to wait for the glue machine to reach the set temperature before use
② The temperature setting is not enough. Set the temperature to the temperature required for the corresponding thickness
2. Bubbles appear
① The temperature is high. Please lower the temperature properly
② There are impurities in the rubber roller of the glue machine. Please clean the impurities on the rubber roller
3. Excessive glue wrinkling and unevenness
① The temperature is too high. Please lower the temperature properly
② The rubber roller of the glue machine is uneven. Please check whether the rubber roller is flat and intact
③ The over-glued material is not placed flat: the over-glued material is placed flat and then placed flat into the plastic sealing machine
4. Non-stick paper and photos have foggy white spots
① The temperature is too low. Please raise the temperature appropriately
5. The four edges of the photo are not sticky or the empty edges are blistered
① The pressure of the rubber roller of the gluing machine is not enough. Please tighten the pressure of the rubber roller of the glue machine
② The temperature is not enough. Please raise the temperature

A3 FN335 Laminator Machine for Laminating Photo Cards Portable Thermal Lamination Paper Cutter for Personal Office School Dropshipping